Q-In-Q Commands; Enable Qinq - D-Link DES-1210-52/ME Cli Reference Manual

The Link Aggregation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

enable qinq

disable qinq
show qinq
config qinq ports
config qinq inner_tpid
create vlan_translation
show vlan_translation
delete vlan_translation
Each command is listed in detail, as follows:
enable qinq
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Q-in-Q:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Parameter
{ports [<portlist> | all]}
[<portlist> | all] {role [nni | uni] | outer_tpid <hex 0x1 - 0xffff> | vlan_translation
[enable | disable] | missdrop [enable | disable] | add_inner_tag [<hex 0x1 - 0xffff>
| disable]}
<hex 0x1-0xffff>
[<portlist> | all] [add | replace] cvid <vidlist> svid <vlanid 1-4094>
{cvid <vidlist> | ports <portlist>}
ports [<portlist> | all] {cvid <vidlist>}
To enable the Q-in-Q mode.
enable qinq
The enable qinq command creates a used to enable the Q-in-Q
mode.
When Q-in-Q is enabled, all network port roles will be NNI port and
their outer TPID will be set to 88a8. All existing static VLANs will run
as SP-VLAN. All dynamically learned L2 address will be cleared.
GVRP and STP need to be disabled manually.
If you need to run GVRP on the Switch, firstly enable GVRP
manually. The default setting of Q-in-Q is disabled.
None.
Only administrator or operator-level users can issue this command.
DES-1210-52/ME:5# enable qinq
Command: enable qinq
Success.
DES-1210-52/ME:5#

Q-IN-Q COMMANDS

228
29