Enable Lldp; Disable Lldp; Config Lldp Message_Tx_Interval - D-Link DES-1210-52/ME Cli Reference Manual

Each command is listed in detail, as follows:

enable lldp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable LLDP on the switch:

disable lldp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable LLDP on the switch:

config lldp message_tx_interval

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP message tx interval on the switch:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
To enable LLDP on the switch.
enable lldp
The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
None.
Only Administrator or operator–level users can issue this command.
DES-1210-52/ME:5# enable lldp
Command: enable lldp
Success.
DES-1210-52/ME:5#
To disable LLDP on the switch.
disable lldp
The disable lldp command disables the Link Discovery Protocol
(LLDP) on the switch.
None.
Only Administrator or operator–level users can issue this command.
DES-1210-52/ME:5# disable lldp
Command: disable lldp
Success.
DES-1210-52/ME:5#
To define the lldp message tx interval
config lldp message_tx_interval <sec 5-32768>
The config lldp message_tx_interval defines the lldp message
interval of the incoming messages.
<sec 5-32768> – Defines the message interval time. The range is
between 5 and 32768.
Only Administrator or operator–level users can issue this command.
382