Forwarding Database Commands; Create Fdb - D-Link DES-1210-52/ME Cli Reference Manual

The Forwarding Database commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

create fdb

create multicast_fdb
config multicast_fdb
config fdb aging_time
delete fdb
enable flood_fdb
disable flood_fdb
config flood_fdb
show flood_fdb
clear flood_fdb
show flow_meter
show fdb
config multicast filter
show multicast filter
port_mode
create auto_fdb
delete auto_fdb
show auto_fdb
Each command is listed in detail, as follows:
create fdb
Purpose
Syntax
Description
Parameters
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide

FORWARDING DATABASE COMMANDS

Parameter
<vlan_name 32> <macaddr> port <port 1-52>
<int 1-4094><macaddr>
<integer 1-4094> <macaddr> [add | delete] <portlist>
<sec 10-1000000>
<vlan_name 32> <macaddr>
[log | trap] [enable | disable]
{profile_id <value 1-10> | access_id <value 1-128>}
{port <port 1-52> | vlan <vlan_name 32> | mac_address <macaddr> | static |
aging_time}
<portlist> [forward | filter]
<ipaddr>
<ipaddr>
{<ipaddr>}
To create a static entry in the unicast MAC address forwarding table
(database)
create fdb <vlan_name 32> <macaddr> port <port 1-52>
The create fdb command creates a static entry in the Switch's
unicast MAC address forwarding database.
<vlan_name 32> − The name of the VLAN on which the MAC
address resides.
<macaddr> − The MAC address to be added to the forwarding table.
165
22