Error Code List; Error Codes - Mitsubishi Q01CPU User Manual

Melsec-q series, qcpu
Hide thumbs Also See for Q01CPU:
Table of Contents

Advertisement

12
TROUBLESHOOTING

12.3 Error Code List

The Q series CPU module uses the self diagnostics function to display error information
(on the LED) and stores the information into the special relay SM and special register SD,
when an error occurs in the following situations:
• When the programmable controller is powered ON.
• When the CPU module is switched from STOP to RUN.
• While the CPU module is running.
If an error occurs when a communication request is issued from GX Developer, intelligent
function module or network system to the CPU module, the CPU module returns the error
code (4000

12.3.1 Error codes

Errors are detected by the self diagnostic function of the CPU module or detected during
communication with the CPU module.
The relation between the error detection pattern, error detection location and error code is
shown in Table12.4.
12
- 54
12.3 Error Code List
12.3.1 Error codes
to 4FFF
) to the request source.
H
H
Error detection pattern
Detection by the self
diagnostics function of
CPU module
CPU module
CPU module
Serial communication
module, etc.
CC-Link module
Detection at
communication with CPU
Ethernet module
module
CC-Link IE controller
network module
MELSECNET/H
network module
* 1: CPU module error codes are classified into minor, moderate, major errors as shown below.
• Minor error:
• Moderate error: Errors that may cause the CPU module to stop the operation, e.g., WDT error.
• Major error:
* 2: When detected an error code without being noted in the reference table, please contact your local
Mitsubishi representive.
Table12.4 Reference destination
Error detection
Error code
location
1000 to 10000
4000H to 4FFF
7000H to 7FFF
B000H to BFFF
C000H to CFFF
E000H to EFFF
F000H to FFFF
Errors that may allow the CPU module to continue the operation, e.g., battery
error.
(Error code: 1300 to 10000)
Errors that may cause the CPU module to stop the operation, e.g., RAM error.
(Error code: 1000 to 1299)
Reference
*1*2
Section 12.3.3 to Section 12.3.9
Section 12.3.11
H
Serial Communication User's
H
Manual, etc.
CC-Link System Master/Local
H
Module User's Manual
Ethernet Interface Module User's
H
Manual
CC-Link IE Controller Network
H
System Reference Manual
For Q Corresponding MELSECNET/
H Network System Reference
H
Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents