Mitsubishi Q01CPU User Manual page 112

4
HARDWARE SPECIFICATIONS OF THE CPU MODULE
Item
Program memory
Memory card (RAM)
Flash
Memory
Max. number
card
card
of files stored
(ROM) ATA card
Standard RAM
Standard ROM
No. of times of writing data into the
standard ROM
No. of I/O device points
(No. of points usable on program.)
No. of I/O points
(No. of points accessible to the actual
I/O module.)
Internal relay [M]
Latch relay [L]
Link relay [B]
Timer [T]
Retentive timer [ST]
Counter [C]
Data register [D]
Link register [W]
Annunciator [F]
Edge relay [V]
[R]
File
register
[ZR]
Link special relay [SB]
Link special register [SW]
*5 : Each of parameter, intelligent function module parameter, sequence program, SFC program, device comment, and device initial value
files can be stored.
*6 :The number of points can be changed within the setting range.
( QCPU User's Manual (Function Explanation, Program Fundamentals)
4
- 2 4.1 Performance Specifications
4.1.1 Basic model QCPU
Table4.1 Performance Specifications
Q00JCPU
----
256 points
(X/Y0 to FF)
8192 points by default (M0-8191) (changeable)
2048 points by default (L0 to 2047) (changeable)
2048 points by default (B0 to 7FF) (changeable)
512 points by default (T0 to 511) (changeable)
(Sharing of low- and high-speed timers)
The low- and high-speed timers are specified by the instructions.
The measurement unit of the low- and high-speed timers is set up by parameters.
(Low-speed timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed timer: 0.1 to 100.0ms, 0.1ms unit, 10.0ms by default)
0 point by default (sharing of the low- and high-speed retentive timers) (changeable)
The low- and high-speed retentive timers are specified by the instructions.
The measurement unit of the low- and high-speed retentive timers is set up by parameters.
(Low-speed retentive timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed retentive timer: 0.1 to 100.0ms, 0.1ms unit, 10.0ms by default)
• Normal counter: 512 points
by default (C0 to 511) (changeable)
• Interrupt counter: 128 points max.
(0 point by default, setting by parameters)
11136 points by default (D0 to 11135) (changeable)
2048 points by default (W0 to 7FF) (changeable)
1024 points by default (F0 to 1023) (changeable)
1024 points by default (V0 to 1023) (changeable)
----
----
1024 points (SB0 to 3FF) (The number of device points is fixed.)
1024 points (SW0 to 3FF) (The number of device points is fixed.)
Basic model QCPU
Q00CPU
*5
6
----
----
----
1
*5
6
Max. 100000 times
2048 points (X/Y0 to 7FF)
1024 points (X/Y0 to 3FF)
32768 points (R0 to 32767)/block
(The number of device points is fixed.)
65536 points
(ZR0 to 65535) (The number of device points is fixed.)
Q01CPU