GENERAL
During assembly/installation, use the torque values and service products as in the exploded view.
Clean thread before applying a thread locker.
W ARNING
Torque wrench tightening specifications must strictly be adhered to.
Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc.)
must be replaced.
PROCEDURE
ACG COVER
ACG Cover Removal
▪ Drain engine oil.
▪ Disconnect ACG connector.
▪ Remove the vent hose.
▪ Remove ACG cover retaining screws.
▪ Pull out ACG cover.
ACG Cover Inspection and Cleaning
▪ Check ACG cover for cracks or other damage.
▪ Replace if necessary.
NOTE: Clean all metal components in a
nonferrous metal cleaner.
WARNING
Wear safety glasses and work in a
well-ventilated area when working with
strong chemical products. Also wear
suitable non-absorbent gloves to protect
your hands.
ACG Cover Installation
For installation, reverse the removal procedure.
NOTE: At installation replace ACG cover
gasket.
▪ Apply SEALING COMPOUND on stator cable
grommet as shown in next illustration.
▪ Tighten screws using the following sequence.
▪ Refill engine with recommended oil.
5-1. ENGINE ASSEMBLY
5-21