Right Crankcase Cover Removal; A.c.g. Set Removal; Right Cover Bearing - TGB BLADE 250 Service Manual

To this chapter contents
10. ALTERNATOR/STARTING CLUTCH

Right Crankcase Cover Removal

11 bolts
Remove left
footrest.
Drain out the engine oil and coolant, and then
remove coolant hoses.
Remove water pump cover (4 bolts).
Remove 11 bolts from the right crankcase cover.
Remove the right crankcase cover.
Remove dowel pin and gasket.
Water pump cover bolts
2 screws

A.C.G. Set Removal

Remove 2 mounted screws from pulse generator
and then remove it.
Remove 3 screws from right crankcase cover and
then remove generator coil set.
3 screws

Right Cover Bearing

Cir clip
Inspection
Rotate the bearing with finger to check if the
bearing rotation is in smooth and silent.
Check if the bearing outer parts are closed and
fixed. Replace it if necessary.
Remove the cir clip, and then remove bearing.
Special tool:
Inner bearing puller
10-3