PROCEDURES
VSS (VEHICLE SPEED SENSOR)
VSS Location
▪ The vehicle speed sensor is located on the
right housing of the gearbox.
▪ To reach the VSS, remove the following parts:
- Passenger seat.
- RH side cover.
VSS Wire identification
PIN
COLOR
A
BN/BK
B
PU
C
Black
VSS Input Voltage Test
1. Use the multimeter and select VDC.
2. Turn ignition switch ON.
3. Measure voltage as per following table.
PIN A and PIN B = Battery Voltage
If voltage is not as specified. Test positive and
ground separately.
VSS Signal Test
1. Lift rear of vehicle so that rear wheels are off
the ground.
2. Set transmission to Neutral.
3. Turn ignition switch ON.
4. Set multimeter to VDC.
5. Measure voltage while slowly rotating rear
wheels by hand.
PIN B and PIN C = Alternate reading between
battery voltage and 0 VDC.
NOTE: Since we measure pulsating voltage,
the numeric display will continuously change.
The analog display may be easier to follow.
FUNCTION
12 Volt
Speed signal
Ground
5-4. TRANSMISSION GEARBOX
5-4-3