Drive Belt; Drive Pulley - TGB EST 1000 Service Manual

CVT Draining
If water is present in CVT, it can be drained as
follows:
1. Remove drain bolt.
2. Let water drain from CVT.
3. Reinstall drain bolt.
NOTICE: If any debris entered the CVT, CVT
must be cleaned and inspected.

DRIVE BELT

Drive Belt Removal
NOTICE: In case of a drive belt failure, the CVT,
cover and air outlet must be cleaned.
▪ Remove CVT COVER.
▪ Open driven pulley with GEAR LOCK PIN.
▪ Screw tool in the threaded hole of driven
pulley and tighten to open the pulley.
▪ To remove belt, slip the belt over the top edge
of fixed sheave, as shown.
Drive belt Installation
▪ For installation, reverse the removal
procedure.
▪ Pay attention to following details.
▪ The maximum drive belt life span is obtained
when the drive belt has the proper rotation
direction. Install it so that the arrow printed on
belt is pointing towards front of the vehicle,
viewed from top.

DRIVE PULLEY

DRIVE PULLEY REMOVAL
▪ Remove DRIVE BELT.
▪ Remove the colling fan bolt 、washers and
colling fan as shown.
PDF created with pdfFactory Pro trial version
5-5. CONTINUOUSLY VARIABLE TRANSMISSION
www.pdffactory.com
5-5-3