BRAKE LIGHT SWITCH
Brake Light Switch Location
There are two brake light switches, which
located on the brake liquid distributor, one at
front and other at LH rear.
Brake Light Switch Continuity Test
1. Disconnect brake light switch connector.
2. Using multimeter check switch operation:
Firmly pushed switch = continuity.
Release switch = Open.
▪. If switch is defective, replace with a new one.
▪. If the switch is good, verify wire continuity
between harness connector and ECU
connector.
Brake Light Switch Replacement
1. Disconnect brake light switch connector.
2. Drain rear brake line.
3. Remove brake light switch from distributor.
NOTE: Use shop rag to catch any spilled brake
fluid.
4. Install new sealing washers.
5. Install brake light switch on distributor.
TORQUE:
19 Nm
6. Connect brake light switch connector.
7. Refill and bleed brake system.
7-3. BRAKE SYSTEM AND BODY COVER
7-3-5