7-1. STEERING AND SUSPENSION
Steering Shaft Removal (without EPS)
1. Remove handlebar cover.
2. Remove dashboard support.
3. Loosen handlebar mounting bolts and
remove handlebar.
4. Remove the body top cover.
5. Remove steering shaft bracket and bolts.
6. Remove the inner fender.
7.Remove the cotter pin and castle nut at the
arm plate. Discard the cotter pin.
8. Disconnect the tie-rods from the arm plate.
9. Remove the steering shaft cotter low end pin,
washer and castle nut. Discard the cotter pin.
NOTE: Always install new cotter pin after
removal.
10
. Pull off the steering shaft from the vehicle.
Steering Shaft
Steering Shaft Removal (with EPS)
1. Remove handlebar cover.
2. Remove dashboard support.
3. Loosen handlebar mounting bolts and
remove handlebar.
4. Remove the body top cover.
5. Remove steering shaft bracket and bolts.
6. Remove the inner fender.
7.Remove steering shaft secure bolt and pull
out the shaft.
Torque: 280~320 kgf-cm
NOTE: For detail of the EPS system please
refer to chapter EPS.
7-1-6