ELECTRIC STARTER
Starter Operation Test
Using booster cables, carefully supply current
from a 12 volt battery directly to the starter.
Connect the Black (-) cable first, then connect
the remaining jumper cable from the battery
then to the starter.
If starter turns, test other starting system
components.
Starter Removal
Turn OFF ignition switch.
Disconnect BLACK (-) cable from battery.
WARNING
Always disconnect BLACK (-) cable first
and reconnect last.
Disconnect RED (+) cable from starter.
Clean starter area.
Remove starter-retaining screw.
Carefully pry starter out of the engine
crankcase.
Starter Installation
Installation is the reverse of removal procedure.
Make sure that starter and engine mating
surface are free of debris. Serious problem may
arise if the starter is not properly aligned.
Bring starter close to its location. Rotate it so
that its mounting ear allows installation in
engine crankcase.
Push starter in place and align mounting ear to
install screw. Tighten to the specified torque.
TORQUE: 25 Nm.
Connect the RED (+) cable to the starter and
tighten nut and apply specified product.
8-1. ELECTRIC SYSTEM
8-1-15