Brake Light Switch/Starting Inhibitor - TGB EST 1000 Service Manual

2. MAINTENANCE INFORMATION
Brake
Lining Wear
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
● To check front brake lining must be remove
front wheel first.
● It is not necessary to remove brake hose
when replacing the brake lining.
Brake
Lining
7-3)
Make sure the brake lining condition. Replace
the lining if the brake lining wear limitation
groove close to the brake disc.
Caution
● Do not operate the brake lever after the
clipper removed to avoid clipping the brake
lining.
● In order to maintain brake power balance, the
brake lining must be replaced with one set.
Brake Light Switch/Starting
Inhibitor Switch
The brake light switch is to light up brake light as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.
2-8
PDF created with pdfFactory Pro trial version
Replacement (refer chapter
www.pdffactory.com