Driver Installation on Red Hat Linux 7.3
The standard Linux installation procedure will install the graphic
driver for the VGA chip. However, under Red Hat Linux 7.3 or
higher, the standard VGA driver is not fully compatible with the
C&T69000 VGA chip. The installation of Red Hat Linux 7.3 may
hang after entering X-Windows.
To fix this compatibility issue, two configuration files must be
modified under text mode. Both files are locate in the /etc/X11
directory.
XF86Config
. . . . . . . .
Identifier"Chips & Technologies CT69000"
VendorName"CHIPS 69000 Super VGA"
# Option "noaccel"
# Option "no_bitblt" <- unmark this item, remove '#'
# Option .......
# Option .......
XF86Config-4
. . . . . . . .
Section"Device"
Identifier"Chips & Technologies CT69000"
Driver"chips"
VendorName"Chips & Technologies CT69000"
BoardName"Chips & Technologies CT69000"
Option "noaccel"
Option "no_bitblt"
Device Driver Installation
<- unmark this item, remove '#'
<- add this item
<- add this item
59
Need help?
Do you have a question about the cPCI-6810 and is the answer not in the manual?