Vga Drivers Installation; Driver Installation On Windows Nt - ADLINK Technology cPCI-6810 User Manual

4.1 VGA Drivers Installation

This section describes the VGA driver installation for the onboard
VGA controller M69000. The relative drivers are located in
X:\CHIPDRV\VGA\69000 directory of the ADLINK CD: where X: is
the location of the CD-ROM drive. The VGA drivers for Windows
98/95, Windows NT, and Windows 2000 are included.

Driver Installation on Windows NT

Windows NT may install the standard VGA driver. It is recommend
that the most recently updated driver be installed manually, which
is shipped with the ADLINK CD to ensure compatibility. After
installing Windows NT, follow the instructions below to update to
the newer driver.
1. From the Control Panel, double-click the Display icon.
2. Click the Settings tab, then Display Type..., and click
Change...
3. Insert the ADLINK CD and click Have Disk.
4. Browse for the M69000 driver in the following path:
X:\CHIPDRV\VGA\ 69000\NT40, highlight
oemsetup.inf, click OPEN, then OK.
5. A window will appear and display chips Video
Accelerator (65545/48/50/54/55 68554 69000), click OK,
then Yes to continue.
6. An Installation Driver window will appear indicating a
successful installation, Click OK to continue.
7. Click Close
8. Click Close, then restart the computer to activate the
new driver.
Note: If the driver does not work after installing the VGA/
AGP drivers, this may be caused by failing to install
the NT service pack in advance. To fix this problem,
install NT service pack 4 or higher to enable AGP
capability.
58 Device Driver Installation