Table of Contents
Advertisement
10. Install the TPM security rivet by pressing the rivet firmly into the system board.
11. If removed from slot 9, install the expansion board.
12. Connect any required internal cables.
13. Install the drive cage assembly.
14. Connect all cables to the drive backplane.
15. Install the air baffle.
If the 4:1 riser signal cable or Smart Storage Battery are installed in the air baffle, reconnect the cables to
the risers. For more information, see "Installing the air baffle."
16. Install the access panel.
17. Install the server into the chassis.
18. Connect all peripheral cables to the server .
19. Power up the server .
Retaining the recovery key/password
About this task
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery key/
Retaining the recovery key/password
109
Hide quick links:
Advertisement
Table of Contents
