Installing A Dimm; Pci Riser Module Options; Installing The 4:1 Pci Riser Modules - HPE ProLiant XL270d Gen9 User Manual

Installing a DIMM

Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server .
4. Remove the server from the chassis .
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. Remove the air baffle.
8. Open the DIMM slot latches.
9. Install the DIMM.
CAUTION:
To prevent damage to the server, ensure that all DIMM latches are in closed and locked position
before installing the air baffle.
10. Install the air baffle.
If the 4:1 riser signal cable or Smart Storage Battery are installed in the air baffle, reconnect the cables to
the risers. For more information, see "Installing the air baffle."
11. Install the access panel.
12. Install the server into the chassis.
13. Connect all peripheral cables to the server .
14. Power up the server .

PCI riser module options

For more information on installing GPU accelerators, see "GPU accelerator options."
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the Hewlett Packard Enterprise website .

Installing the 4:1 PCI riser modules

About this task
To install the component:
Installing a DIMM 45