Table of Contents
Advertisement
CAUTION:
Heatsinks specified for processor 1 and 2 are not interchangeable. Be sure to note the appropriate
orientation on the heatsink label.
CAUTION:
Heatsink retaining screws should be tightened or loosened in diagonally opposite pairs (in an "X"
pattern). Do not overtighten the screws as this can damage the board, connectors, or screws.
14. Install the heatsink:
a. Position the heatsink on the processor backplate.
b. Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
c. Finish the installation by completely tightening the screws in the same sequence.
15. Install the air baffle.
If the 4:1 riser signal cable or Smart Storage Battery are installed in the air baffle, reconnect the cables to
the risers. For more information, see "Installing the air baffle."
16. Install the access panel.
17. Install the server into the chassis.
18. Connect all peripheral cables to the server .
19. Power up the server .
Memory options
IMPORTANT:
This server does not support mixing LRDIMMs or RDIMMs. Attempting to mix any combination of these
DIMMs can cause the node to halt during BIOS initialization.
The memory subsystem in this node can support LRDIMMs and RDIMMs:
•
RDIMMs offer address parity protection.
•
LRDIMMs support higher densities than single- and dual-rank RDIMMs, and higher speeds than quad-rank
RDIMMs. This support enables you to install more high capacity DIMMs, resulting in higher system
capacities and higher bandwidth.
40
Memory options
Hide quick links:
Advertisement
Table of Contents
