Installing The Nvidia K40 Gpu Enablement Kit - HPE ProLiant XL270d Gen9 User Manual

Installing the NVIDIA K40 GPU enablement kit

About this task
Depending on the existing server configuration, some or all of the following procedures may apply.
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the Hewlett Packard Enterprise website .
To install the component:
Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server front panel.
4. Remove the server from the chassis.
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. Remove the side panel.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
CAUTION:
The mixing of different GPU accelerator models is not supported.
8. If NVIDIA K40 GPUs are already installed in the server, and additional K40 GPUs are now being
installed, remove the GPU blank:
a. Loosen the captive screw.
b. Using both hands, gently pull the tab and the rear of the GPU blank.
c. Slide out the GPU blank from the server.
9. If NVIDIA K40 GPUs are not installed in the server, remove all GPUs:
a. Loosen the captive screw.
b. Using both hands, gently pull the tab and the rear support bracket to slide out the GPU to access the
power cable.
82 Installing the NVIDIA K40 GPU enablement kit