Table of Contents
Advertisement
Installing the expansion board
About this task
CAUTION:
Hewlett Packard Enterprise recommends performing a complete backup of all server data before
performing a controller or adapter installation or removal.
To install the component:
Procedure
1.
Back up all server data.
2.
Power down the server .
3.
Disconnect all peripheral cables from the server .
4.
Remove the server from the chassis.
5.
Place the server on a sturdy, level surface.
6.
Remove the access panel.
7.
Remove the air baffle.
8.
Disconnect all cables from the drive backplane.
9.
Remove the drive cage assembly.
NOTE: A second processor is required to install an expansion board in slot 10 of the right 4:1 PCI
riser module.
10. Identify the expansion slot compatible with the new option, and then remove the PCI blank.
•
Slot 9
•
Slot 10
102
Installing the expansion board
Hide quick links:
Advertisement
Table of Contents
