Flash Messages - GE 750 Instruction Manual

750/760
Feeder Management Relay

Flash Messages

4–8
Flash messages are warning, error, or general information messages displayed in
response to certain key presses. The length of time these messages remain
displayed can be programmed in
. The factory default flash message time is 4 seconds.
TIME
This flash message is displayed in response to the ENTER
ADJUSTED VALUE
key, while on a setpoint message with a numerical value.
HAS BEEN STORED
The edited value had to be adjusted to the nearest
multiple of the step value before it was stored.
This flash message is displayed in response to executing
COMMAND IS BEING
a command message. Entering "Yes" at a command will
EXECUTED
display the message
again will perform the requested command and display
this flash message.
This flash message is displayed in response to pressing
DEFAULT MESSAGE
the decimal key, followed by the ENTER key twice, on any
HAS BEEN ADDED
message in
This message is displayed in response to pressing the
DEFAULT MESSAGE
decimal key, followed by the ENTER key twice, on any
HAS BEEN REMOVED
selected default message in
MESSAGES
This flash message is displayed in response to an
ENTER PASSCODE
incorrectly entered passcode when attempting to enable
IS INVALID
or disable setpoint access.
This message is displayed while changing the password
ENTRY MISMATCH -
with the
CODE NOT STORED
setpoint. If the passcode entered at the
ENTER A NEW PASSCODE
one entered
the relay dumps the new passcode and display this
message
This flash message is displayed in response to pressing
INVALID KEY: MUST
the OPEN or close keys while the relay is in Remote Mode.
BE IN LOCAL MODE
The relay must be put into Local Mode in order for these
keys to be operational.
This message is displayed in response to changing the
NEW PASSCODE
programmed passcode from the
STORED
PASSCODE
to change the passcode were followed correctly and the
new passcode was stored as entered.
This flash message is displayed in response to the ENTER
NEW SETPOINT
key while on any setpoint message. The edited value was
STORED
stored as entered.
This flash message is displayed in response to the
NO CONDITIONS ARE
MESSAGE
CURRENTLY ACTIVE
MESSAGES
active conditions to display in the diagnostic message
queue.
This flash message is displayed in response to the ENTER
OUT OF RANGE -
key while on a setpoint message or numerical value. The
VALUE NOT STORED
edited value was either less than the minimum or greater
than the maximum acceptable values for the edited
setpoint and as a result was not stored.
http://www.GEmultilin.com
S1 RELAY SETUP FRONT PANEL
ARE YOU SURE?
S1 RELAY SETUP DEFAULT MESSAGES
S1 RELAY SETUP
.
S1 RELAY SETUP PASSCODE
prompt is different from the
PLEASE ENTER A NEW PASSCODE
setpoint. The directions
CHANGE PASSCODE
key when the relay is displaying
and the Message LED is off. There are no
Relay Messages
FLASH MESSAGE
. Entering "Yes"
.
DEFAULT
CHANGE PASSCODE
PLEASE RE-
prompt,
S1 RELAY SETUP
TARGET
GE Multilin