Working With Setpoints And Setpoint Files; Engaging A Device; Entering Setpoints - GE 750 Instruction Manual

750/760
Feeder Management Relay

Engaging a Device

Entering Setpoints

4–18

Working with Setpoints and Setpoint Files

The EnerVista 750/760 Setup software may be used in on-line mode (relay
connected) to directly communicate with a 750/760 relay. Communicating relays
are organized and grouped by communication interfaces and into sites. Sites may
contain any number of relays selected from the SR or UR product series.
The System Setup page will be used as an example to illustrate the entering of
setpoints. In this example, we will be changing the current sensing setpoints.
1. Establish communications with the relay.
1. Select the Setpoint > System Setup menu item. This can be selected from
the device setpoint tree or the main window menu bar.
2. Select the
PHASE CT PRIMARY
This will display three arrows: two to increment/decrement the value and
another to launch the numerical calculator.
3. Clicking the arrow at the end of the box displays a numerical keypad interface
that allows the user to enter a value within the setpoint range displayed near
the top of the keypad:
Click Accept to exit from the keypad and keep the new value. Click on Cancel
to exit from the keypad and retain the old value.
http://www.GEmultilin.com
Working with Setpoints and Setpoint Files
setpoint by clicking anywhere in the parameter box.
GE Multilin