Unit Withdrawal And Insertion - GE 750 Instruction Manual

Mechanical Installation
Unit Withdrawal and
Insertion
CAUTION
GE Multilin
TURN OFF CONTROL POWER BEFORE DRAWING OUT OR RE-
INSERTING THE RELAY TO PREVENT MALOPERATION!
CAUTION
If an attempt is made to install a relay into a non-matching case, the case's
configuration pin will prevent full insertion. Applying a strong force in this
instance will result in damage to the relay and case.
If using an ethernet connection, refer to Ethernet Connection on page 3–4 before
starting the following procedure.
To remove the unit from the case:
1. Open the door by pulling from the top or bottom of its right side. It will rotate to
the left about its hinges.
2. Press upward on the locking latch, which is located below the handle, and hold
in its raised position. The tip of a small screwdriver may prove helpful in this
operation.
FIGURE 3–5: Press Latch Up and Pull Handle
3. With the latch raised, pull the center of the handle outward. Once disengaged,
continue rotating the handle up to the stop position.
FIGURE 3–6: Rotating Handle to Stop Position
4. When the stop position is reached, the locking mechanism will release. The
relay will now slide out of the case when pulled from its handle. To free the
relay, it may sometimes be necessary to adjust the handle position slightly.
FIGURE 3–7: Sliding the Unit out of the Case
http://www.GEmultilin.com
750/760
Feeder Management Relay
3–3