Flash Messages; Description - GE 750 Instruction Manual

5 FRONT PANEL OPERATION

5.5 FLASH MESSAGES

Flash messages are warning, error, or general information messages displayed in response to certain key
presses. The length of time these messages remain displayed can be programmed in
PANEL \ FLASH MESSAGE TIME
ADJUSTED VALUE
HAS BEEN STORED
COMMAND IS BEING
EXECUTED
DEFAULT MESSAGE
HAS BEEN ADDED
DEFAULT MESSAGE
HAS BEEN REMOVED
ENTER PASSCODE
IS INVALID
ENTRY MISMATCH -
CODE NOT STORED
INVALID KEY: MUST
BE IN LOCAL MODE
NEW PASSCODE HAS
BEEN STORED
NEW SETPOINT HAS
BEEN STORED
NO CONDITIONS ARE
CURRENTLY ACTIVE
GE Power Management
Courtesy of NationalSwitchgear.com
. The factory default flash message time is 4 seconds.
This flash message is displayed in response to the
setpoint message with a numerical value. The edited value had to be
adjusted to the nearest multiple of the step value before it was stored.
This flash message is displayed in response to executing a command mes-
sage. Entering Yes at a command message will display the message "ARE
YOU SURE?". Entering Yes again will perform the requested command and
display this flash message.
This flash message is displayed in response to pressing the
lowed by the key twice, on any setpoint or actual value message in
E N T E R
the subgroup
S1 \ RELAY SETUP \ DEFAULT MESSAGES
This flash message is displayed in response to pressing the
lowed by the key twice, on one of the selected default messages in
E N T E R
the subgroup
S1 \ RELAY SETUP \ DEFAULT MESSAGES
This flash message is displayed in response to an incorrectly entered pass-
code when attempting to enable or disable setpoint access.
This flash message is displayed while changing the programmed password
from the command message
. If the passcode entered at the stage "PLEASE RE-ENTER A NEW
CODE?
PASSCODE" is different from the one entered at the stage "PLEASE ENTER
A NEW PASSCODE:", the relay will not store the entered passcode and dis-
play this flash message
This flash message is displayed in response to pressing the
keys while the relay is in REMOTE mode. The relay must be put into
C L O S E
LOCAL mode in order for these keys to be operational.
This flash message is displayed in response to changing the programmed
passcode from the command message
. The directions to change the passcode were followed correctly
PASSCODE?
and the new passcode was stored as entered.
This flash message is displayed in response to the
setpoint message. The edited value was stored as entered.
This flash message is displayed in response to the
MESSAGE indicator is off. There are no active conditions to display in the
diagnostic message queue.
750/760 Feeder Management Relay
5.5 FLASH MESSAGES
S1 RELAY SETUP \ FRONT
E N T E R
S1 RELAY SETUP \ PASSCODE \ CHANGE PASS-
S1 RELAY SETUP \ PASSCODE \ CHANGE
E N T E R
N E X T

5.5.1 DESCRIPTION

key, while on a
key, fol-
key, fol-
5
or
O P E N
key while on any
key while the
5-
7