Drawout Case; Installation - GE 750 Instruction Manual

750/760
Feeder Management Relay

Installation

3–2
FIGURE 3–2: Drawout Case Seal
The 750/760 can be mounted alone or adjacent to another SR-series unit on a
standard 19-inch rack panel. Panel cutout dimensions for both conditions shown
below. When planning the location of your panel cutout, ensure provision is made
for the front door to swing open without interference to or from adjacent equipment.
FIGURE 3–3: Single and Double Unit Panel Cutouts
Before mounting the relay in the supporting panel, remove the unit from the case.
From the front of the panel, slide the empty case into the cutout. To ensure the front
bezel is flush with the panel, apply pressure to the bezel's front while bending the
retaining tabs 90°. These tabs are located on the sides and bottom of the case and
appear as shown in the illustration. After bending all tabs, the case will be securely
mounted so that its relay can be inserted. The unit is now ready for panel wiring.
FIGURE 3–4: Mounting Tabs
http://www.GEmultilin.com
Mechanical Installation
DRAWOUT
CASE SEAL
GE Multilin