Installation; Mod 008 Upgrade - GE 750 Instruction Manual

750/760
Feeder Management Relay

Installation

INSTALLATION
WARNING

Mod 008 Upgrade

MOD 008
UPGRADE
5–16
PATH: SETPOINTS S1 RELAY SETUP
[ ] 760 OPERATION:
Not Ready
RESET TRIP COUNTER
MESSAGE
DATA? No
RESET ARCING CURRENT
MESSAGE
DATA? No
RESET AR COUNT
MESSAGE
DATA? No
RESET AR RATE
MESSAGE
DATA? No
The self-test warning message will be displayed until
Relay Not Ready
SETUP INSTALLATION 760 OPERATION
installation of a relay whose setpoints have not been entered for the required
application. This setpoint is defaulted to "Not Ready" when the relay leaves the
factory.
These setpoints should be used on a new installation or after new equipment has
been installed.
The
RESET TRIP COUNTER DATA
updates the
A3 MAINTENANCE
value. The
RESET ARCING CURRENT
the
A3 MAINTENANCE ARCING CURRENT
The
RESET AR COUNT DATA
updates the
A1 STATUS AR
setpoint clears the autoreclose shot rate value and updates the
DATA
date. These two setpoints are applicable to the 760 only.
CURRENT LAST RESET
PATH: SETPOINTS S1 RELAY SETUP
[ ] ENABLE MOD 008?
Disabled
ENTER PASSCODE:
MESSAGE
00000000000000
UPGRADE OPTIONS?
MESSAGE
No
These setpoints are shown if the Mod 008 Reverse Power option has been ordered
with the 750/760 relay. To order this option, please contact GE Multilin with the
serial number of the relay. Refer to Reverse Power on page 8–1 for the complete
procedure for installing and verifying the Reverse Power element.
These setpoints are shown only if the feature has been enabled.
http://www.GEmultilin.com
INSTALLATION
Range: Ready, Not Ready. Reads as
Range: Yes, No
Range: Yes, No
Range: Yes, No. Message is only seen
Range: Yes, No. Message is only seen
is set to "Ready". This warns against the
setpoint clears all accumulated trip counter values and
TRIP COUNTERS TRIP COUNTERS LAST RESET
setpoint clears all arcing current data and updates
ARCING CURRENT LAST RESET
setpoint clears the autoreclose shot count value and
AR SHOT COUNT LAST RESET
MOD 008 UPGRADE
Range: Disabled, Enabled
Range: 16 alphanumeric characters
Range: Yes, No.
S1 Relay Setup
750
OPERATION
for 750 relays
in 760 relays.
in 760 relays.
S1 RELAY
actual
date.
date. The
RESET AR RATE
ARCING
GE Multilin