Flash Messages; Label Removal - GE 845 Instruction Manual

FRONT CONTROL PANEL INTERFACE

Flash Messages

Label Removal

3–12
Table 3-5: Major Self-test Errors
Self-test Error Latched
Message Target
Message
Out-of-Service No
Major Self-Test Yes
(error code)
Flash messages are warning, error, or general information messages displayed in response
to pressing certain keys. The factory default flash message time is 4 seconds.
The following procedure describes how to use the label removal tool.
1. Bend the tabs of the tool upwards as shown in the image.
Description of How Often the Test
Problem is Performed
DEVICE IN SERVICE On power up and
setting indicates whenever the
relay is not in a DEVICE IN SERVICE
programmed state. setting is altered.
Unit hardware failure Every 1 second
detected
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES
What to do
Program all required
settings and then set the
DEVICE>INSTALLATION>
DEVICE IN SERVICE setting
to "Ready".
Contact the factory and
supply the failure code as
noted on the display.