GE 750 Instruction Manual page 71

Relay Messages
GE Multilin
This flash message is displayed while changing the
PLEASE ENTER A
passcode with the
NON-ZERO PASSCODE
PASSCODE
passcode to "0" when it was already "0".
This flash message is displayed for 5 seconds in response
PRESS [ENTER] TO
to pressing the decimal key, followed by the ENTER key
ADD AS DEFAULT
while displaying any setpoint or actual value message
except those in
Pressing the ENTER key again while this message is
displayed adds the setpoint or actual value message to
the default list.
This message is displayed in response to the VALUE keys
PRESS [ENTER] TO
while on a setpoint message with a text entry value. The
BEGIN TEXT EDIT
ENTER key must be pressed to begin editing.
This flash message is displayed for 5 seconds in response
PRESS [ENTER] TO
to pressing the decimal key, followed by the ENTER key
REMOVE MESSAGE
while displaying one of the selected default messages in
the subgroup
Pressing the ENTER key again while this message is
displayed removes the default message from the list.
This flash message is displayed in response to any
PRESSED KEY
pressed key that has no meaning in the current context.
IS INVALID HERE
This flash message is displayed in response to the RESET
RESETTING LATCHED
key. All active latched conditions (trips, alarms, or
CONDITIONS
latched relays) for which the activating condition is no
longer present will be cleared.
This flash message is displayed in response to the ENTER
SETPOINT ACCESS
key while on any setpoint message. Setpoint access is
DENIED (PASSCODE)
restricted because the programmed passcode has not
been entered to allow access.
This flash message is displayed in response to the ENTER
SETPOINT ACCESS
key while on any setpoint message. Setpoint access is
DENIED (SWITCH)
restricted because the setpoint access terminals have not
been connected.
This flash message is displayed in response to correctly
SETPOINT ACCESS
entering the programmed passcode at the
IS NOT ALLOWED
PASSCODE
command
successfully executed and setpoints can be changed and
entered.
This flash message is displayed in response to entering
SETPOINT ACCESS
the correct programmed passcode at the
IS NOW RESTRICTED
PASSCODE
The command to restrict access to setpoints has been
successfully executed and setpoints cannot be changed.
http://www.GEmultilin.com
Feeder Management Relay
S1 RELAY SETUP PASSCODE
setpoint. An attempt was made to change the
S1 RELAY SETUP
S1 RELAY SETUP
ALLOW ACCESS TO SETPOINTS
to allow access to setpoints
RESTRICT ACCESS TO SETPOINTS
750/760
CHANGE
.
DEFAULT MESSAGES
.
DEFAULT MESSAGES
S1 RELAY SETUP
setpoint. The
has been
S1 RELAY SETUP
setpoint.
4–9