750/760
Electrical Installation
Feeder Management Relay
FIGURE 3–21: RS422 Wiring Diagram
RS232 Communications
The 9-pin RS232 serial port located on the front panel is used in conjunction with
the EnerVista 750/760 Setup software for programming setpoints and upgrading
relay firmware. A standard 9-pin RS232 cable is used to connect the relay to a
personal computer as shown below. When downloading new firmware, ensure
the relay address is set to 1 and the baud rate is set to 9600.
FIGURE 3–22: RS232 Connection
GE Multilin
3–16
http://www.GEmultilin.com