Getting Started With Itp; Realpresence Otx Studio Monitor Lifts; Automatically Controlling Monitor Lifts; Manually Controlling Monitor Lifts - Polycom RealPresence Immersive Studio Administrator's Manual

Getting Started with ITP

Topics:
•

RealPresence OTX Studio Monitor Lifts

• Obtaining the Network Parameters
The RealPresence Immersive Studio, RealPresence Immersive Studio Flex, and RealPresence OTX
Studio systems are state-of-the-art visual collaboration tools. With crisp, clean video and crystal-clear
sound, RealPresence ITP systems provide natural video conferencing interaction using the most robust
video communications technology.
If your organization has signed on for Video Network Operations Center (VNOC) services, the VNOC will
handle many telepresence conferencing tasks for you.
RealPresence OTX Studio Monitor Lifts
You can raise or lower RealPresence OTX Studio table monitor lifts for optimum conference viewing. The
monitor lifts are partially automated and can also be manually controlled.

Automatically Controlling Monitor Lifts

All three monitors automatically raise or lower in the following circumstances:
• When content is started the monitors rise.
• When content is used during a call and the call ends, the monitors lower.
• When the system powers on or during a restart the monitors lower. During initial start-up and
restarts all monitor controls are locked.

Manually Controlling Monitor Lifts

After initial start-up, the individual buttons in the RealPresence OTX Studio table toggle the state of the
associated lift. Full extension or retraction takes about 15 seconds. If you use the buttons while the
monitors are moving, the direction the monitors are traveling reverses. The monitors will only fully stop in
the middle of travel during a mechanical collision or a system power failure.

Control the Monitor Lifts from the Web Interface

You can raise or lower RealPresence OTX Studio table monitor lifts for optimum conference viewing. You
can raise or lower all three monitors from the web interface.
Procedure
» Go to Utilities > Tools > OTX Setup and select Up or Down.
Polycom, Inc. 5