Polycom RealPresence Immersive Studio Administrator's Manual page 16

Setting
Privacy Algorithm
Privacy Password
Engine ID
Listening Port
Transport Protocol
Destination Address1
Destination Address2
Destination Address3
Polycom, Inc.
Description
Specifies the type of SNMPv3 cryptography privacy
algorithm used:
• CFB-AES128
• CBC-DES
Specifies the SNMPv3 privacy (encryption)
password. The maximum length is 48 characters.
Specifies the unique ID of the SNMPv3 engine.
This setting might be needed for matching the
configuration of an SNMP console application. The
Engine ID is automatically generated, but you can
create your own ID, as long as it's between 10 and
32 hexadecimal digits. Each group of 2 hex digits
can be separated by a colon character (:) to form a
full 8-bit value. A single hex digit delimited on each
side with a colon is equivalent to the same hex digit
with a leading zero (therefore, :F: is equivalent to :
0f:).
The ID cannot be all zeros or all Fs.
Specifies the port number SNMP uses to listen for
messages. The default listening port is 161.
Specifies the transport protocol used:
• TCP
• UDP
Specifies the IP addresses of the computers you
intend to use as your network management station
and to which SNMP traps will be sent.
Each address row has four settings:
1 IP Address (accepts IPv4 and IPv6 addresses,
host names, and FQDNs)
2 Message Type (Trap, Inform)
3 SNMP protocol version (v1, v2c, v3)
4 Port (the default is 162)
Disabling the Port setting disables the
corresponding Destination Address.
SNMP Condition Reports
14