Configuring General System Settings; Name The System; Set The Date And Time - Polycom RealPresence Immersive Studio Administrator's Manual

Configuring General System Settings

Topics:
•

Name the System

•

Set the Date and Time

This section provides information on how to configure general system settings for RealPresence ITP :
Name the System
The System Name screen enables you to name your system and your center, left, and right server
names. When naming the sites, keep the following in mind:
• Do not use site names which are the same or similar (site names with a trailing numeral digit, for
instance) for Group Series codecs that are part of RealPresence ITP room systems and for
individual endpoints that are not part of RealPresence ITP room systems.
• For individual endpoints, disconnected from a telepresence conference, use the same or similar
names as each other and as RealPresence ITP systems, then Polycom MLA sometimes mistakenly
identifies the individual endpoints as Immersive Studio, Immersive Studio Flex, OTX Studio, or ITP
systems.
• The TYPE OF ITP field enables Polycom Multipoint Layout Application to find the correct
RealPresence ITP room, when the RealPresence ITP room is part of a telepresence conference
participants list, but disconnected from the conference.
Procedure
1. Go to Admin Settings > General Settings > System Settings > System Name.
The first character of a System Name must be a letter or a number. The System Name cannot
begin with the dollar sign ($) or underscore (_) character.
2. In the System Name field, enter a name as described below.
3. Enter the <SiteName>[TYPE OF ITP].
"[TYPE OF ITP]" is optional and specifies the type of ITP room: "RIS" for RealPresence Immersive
Studio
When you assign a system name for the main codec, unique identities for the left and right codecs
are automatically generated. The naming convention is as follows.
<SiteName>[TYPE OF ITP]_M_N where:
• M = number of systems (for RealPresence Immersive Studio, this value is 3)
• N = 1 for the primary system, 2 for the left system, and 3 for the right system
The system name is displayed on the screen for the far site when you are in a call.
4. Click Save.
Set the Date and Time
System Time settings enable you to specify how date and time values are displayed.
Polycom, Inc. 15