Configuring The Ip Addresses Of The Component Codecs; Exit Immersive Mode; Change The Ip Address Of The Primary Codec; Change The Ip Address Of The Secondary Codecs - Polycom RealPresence Immersive Studio Administrator's Manual

Configuring the IP Addresses of the Component
Codecs
The following procedures describe how to change the IP addresses of the main and secondary codecs
while they are not in Immersive mode.

Exit Immersive Mode

In order to change the codec IP addresses, you must exit Immersive Mode.
Procedure
1. Go to the Immersive page in the primary codec web user interface.
2. Change the system from Primary to Standalone.

Change the IP Address of the Primary Codec

Follow these procedures to change the IP address of the Primary codec.
Procedure
1. In the primary codec web UI, go to Admin Settings > Network > LAN Properties for the primary
codec.
2. In the IP Address (IPv4) section, in the IP Address field, specify how the system obtains an IP
address.
• Obtain IP Address Automatically—Select this option if the system gets an IP address from
the DHCP server on the LAN.
• Enter IP Address Manually—Select this option if the IP address will not be assigned
automatically.
1. For the manual IP address option, enter the new information in the Your IP Address
is, Default Gateway, and Subnet Mask fields.
2. Save the changes.
After you changed the IP address of the primary codec, the secondary codecs might
start the reboot cycle because they have lost connection with the primary codec. In
addition, the primary display shows black video.
3. Go to Admin Settings > Immersive.
4. In the Left Static IP Address and Right Static IP Address fields, enter the updated IP addresses
for the left and right secondary codecs respectively.
5. Enter Admin ID and Password credentials if you use them.
6. Select Connect.
All codecs reboot.

Change the IP Address of the Secondary Codecs

Follow these procedures to change the IP address of the Secondary codecs.
Polycom, Inc.
Configuring Network Settings
20