Set Password Requirements - Polycom RealPresence Immersive Studio Administrator's Manual

Setting
Enable Diagnostics Port Idle Session Timeout
Enable API Port Idle Session Timeout
Enable Whitelist
Idle Session Timeout in Minutes
Maximum Number of Active Sessions

Set Password Requirements

You can configure password policies for Admin, User, Meeting, and Remote Access passwords. These
password settings can ensure that strong passwords are used. Polycom strongly recommends that you
create an Admin password for your system.
Procedure
1. Go to Admin Settings > Security > Local Accounts > Password Requirements.
2. Configure the following settings.
Password Policy Settings
Setting
Minimum Length
Require Lowercase Letters
Require Uppercase Letters
Require Numbers
Polycom, Inc.
Description
Specifies whether to allow the diagnostics port to
time out at the configured time interval or not. The
timeout setting is set under Idle Session Timeout
in Minutes.
Specifies whether to allow the API port to time out
at the configured time
interval or not. The timeout setting is set under Idle
Session Timeout in
Minutes.
Specifies whether the system web interface ports
accept connections only from specified IP
addresses.
Specifies the number of minutes your web interface
session can be idle before the session times out.
Specifies the maximum number of users who can
be logged in to and using your system through
Telnet or the web interface at the same time.
Description
Specifies the minimum number of characters
required for a valid password.
Specifies whether a valid password must contain
one or more lowercase letters.
Specifies whether a valid password must contain
one or more uppercase letters.
Specifies whether a valid password must contain
one or more numbers.
Securing the System
37