Calibrate The Microphones - Polycom RealPresence Immersive Studio Administrator's Manual

Calibrate the Microphones

Microphone calibration is required before making TIP calls. The Microphone Calibration Screen does not
provide any indication of whether the calibration process has been performed for any given seat.
Carefully track the seats as you perform the calibration so no seat is omitted.
Procedure
1. In the primary codec web user interface, go to Diagnostics > Audio and Video Tests >
Microphone Calibration.
The Microphone Calibration screen displays. The screen displays a representation of the furniture
in the room with circles representing the seating locations.
2. Sit in any of the seats at the table.
It may be convenient to start at the far right or left seat and work your way around the table(s).
3. On the Microphone Calibration screen, select the circle corresponding to your current seated
location.
A message box showing progress appears.
4. Face the monitors and speak normally.
After a few seconds, a successful calibration message appears.
If calibration fails, a calibration failure message appears. Close the message and try again. If you
are unable to achieve a successful calibration, verify proper microphone installation and try again.
Contact Polycom Support to verify proper installation, if necessary.
5. Close the message box.
6. Repeat steps 2 through 5 for all seating locations.
Polycom, Inc.
Audio Settings
54