Configuring Network Settings; Configure Lan Properties - Polycom RealPresence Immersive Studio Administrator's Manual

Configuring Network Settings

Topics:
•

Configure LAN Properties

• Configuring the IP Addresses of the Component Codecs
• Configure Servers
• Immersive Settings
• Room Control Devices
Configure LAN Properties
You can configure LAN properties for the RealPresence ITP system. LAN properties are controlled
individually by the three systems that are part of the RealPresence Immersive Studio setup. You must
configure each system individually.
Procedure
1. In the primary codec web UI, go to Admin Settings > Network > LAN Properties.
2. Configure the following IP Address (IPv4) settings on the LAN Properties screen.
A static IPv4 address is required for each codec.
IP Address (IPv4) Settings
Setting
IP Address
Your IP Address is
Default Gateway
Polycom, Inc.
Description
Specifies how the system obtains an IP address.
• Obtain IP Address Automatically—
Select if the system gets an IP address
from the DHCP server on the LAN.
• Enter IP Address Manually—Select if
the IP address will not be assigned
automatically.
If the system obtains its IP address automatically,
this area displays the IP address currently assigned
to the system.
If you selected Enter IP Address Manually, enter
the IP address here.
Displays the gateway currently assigned to the
system.
If the system does not automatically obtain a
gateway IP address, enter one here.
17