Configure Sip Settings - Polycom RealPresence Immersive Studio Administrator's Manual

Setting
Quality Preference

Configure SIP Settings

If your network supports the Session Initiation Protocol (SIP), you can use SIP to connect IP calls.The
SIP protocol has been widely adapted for voice over IP communications and basic video conferencing;
however, many of the advanced video conferencing capabilities are not yet standardized. Many
capabilities also depend on the SIP server.
The following are examples of features that are not supported using SIP:
• Cascaded multipoint in SIP calls.
• Meeting passwords. If you set a meeting password, SIP endpoints will be unable to dial in to a
multipoint call.
Procedure
1. In the web interface, go to Admin Settings > Network > IP Network > SIP.
2. Configure these settings.
SIP Settings
Setting
Enable SIP
Enable AS-SIP
SIP Server Configuration
Polycom, Inc.
Configuring Network Settings
Description
Specifies which stream has precedence when
attempting to improve network quality issues:
• Both (People and Content Streams)
• People Streams
• Content Streams
This setting is not available when the
Automatically Adjust People/Content
Bandwidth setting is enabled.
Description
Enables the SIP settings to be displayed and
configured.
Not supported.
Specifies whether to automatically or manually set
the SIP server's IP address.
If you select Auto, the Transport Protocol,
Registrar Server, and Proxy Server settings cannot
be edited. If you select Specify, those settings are
editable.
22