Polycom RealPresence Immersive Studio Administrator's Manual page 20

Setting
Subnet Mask
3. The DNS Server address fields are populated automatically when the IPv4 Address is
automatically obtained.
If the IPv4 address is not obtained automatically, enter the DNS Server addresses.
4. Configure the following LAN Options settings.
LAN Options
Setting
Host Name
Domain Name
Autonegotiation
LAN Speed
Duplex Mode
Ignore Redirect Messages
Polycom, Inc.
Configuring Network Settings
Description
Displays the subnet mask currently assigned to the
system.
If the system does not automatically obtain a
subnet mask, enter one here.
Description
Indicates the system's DNS name.
Displays the domain name currently assigned to
the system.
If the system does not automatically obtain a
domain name, enter one here.
Specifies whether the network switch should
automatically negotiate the LAN speed and duplex
mode. If this setting is enabled, the LAN Speed
and Duplex Mode settings become read only.
Polycom and IEEE802.3 recommend that you use
autonegotiation to avoid network issues.
Specifies whether to use 10 Mbps, 100 Mbps, or
1000 Mbps for the LAN speed.
Note that the switch must support the speed that
you choose.
Specifies the duplex mode to use.
Note that the switch must support the Duplex mode
that you choose.
Enables the RealPresence ITP system to ignore
redirect messages from network routers. A redirect
message tells the endpoint to use a different router
than the one it is using.
18