Procedure
1. In the secondary codec web UI, go to Admin Settings > Network > LAN Properties for the
secondary codec.
2. In the IP Address (IPv4) section, in the IP Address field, specify how the system obtains an IP
address.
•
Obtain IP Address Automatically—Select this option if the system gets an IP address from
the DHCP server on the LAN.
•
Enter IP Address Manually—Select this option if the IP address will not be assigned
automatically.
1. For the manual IP address option, enter the new information in the Your IP Address
is, Default Gateway, and Subnet Mask fields.
2. Save the changes.
After you change the IP address of the secondary codec, the codec might start the
reboot cycle because it has lost the SSH connection to the primary codec. In
addition, the main display shows black video.
3. Go to Admin Settings > Immersive for the primary codec.
4. Select the RealPresence Immersive Studio, RealPresence Immersive Studio Flex, or
RealPresence OTX Studio for the System Type.
5. In the Left Static IP Address or Right Static IP Address field, enter the updated IP address for
the applicable secondary codec.
6. Enter Admin ID and Password credentials if you use them.
7. Select Connect.
All codecs reboot.
Configure Network Quality Settings
You can specify how your system responds to network quality issues by configuring the Network Quality
settings; these settings control how your network handles IP packets during video calls.
Procedure
» Use this group of settings to specify how your RealPresence ITP system responds to quality
issues.
Network Quality Settings
Setting
Automatically Adjust People or Content
Bandwidth
Polycom, Inc.
Configuring Network Settings
Description
Specifies whether the system should automatically
adjust the bandwidth necessary for the People
stream or Content stream depending on the relative
complexity of the people video, content video, or
both.
This setting is not available if you select a Quality
Preference.
21
Need help?
Do you have a question about the RealPresence Immersive Studio and is the answer not in the manual?