Hot Plug Compatible Sata/Sas Drive Led - NEC EXP804 User Manual

Chapter 1 General Description

Hot plug compatible SATA/SAS drive LED

No.
1 Position Check LED
2 DISK ACT LED
3 Remove Protect Switch/LED
4 DISK STATUS LED
42
Item Status
Lights in blue
Flashes in blue
Rotates in green
Lights off
Lights in white
Lights off
Lights in green
Flashes in green
Flashes in
amber/green.
Flashes in amber
Lights in amber
Lights off
Important Observe the following precautions when using the auto rebuild function.

During rebuilding, do not power off or restart the device.

When you dismantle or install the hard disk drive, take a interval of 90
seconds or longer.

If there is another hard disk drive under rebuilding, do not change the
hard disk drive.
Express5800/R120h-1M User's Guide
4. Names and Functions of Parts
Description
The drive is identified by the host application
Firmware on the drive carrier is being
updated or requires updating
Drive is working
Drive is not working
Do not remove the drive. Removing a drive
causes one or more logical drives to fail.
Even if the drive is removed, the logical drive
will not fail.
A drive is a member of one or more logical
drives.
Rebuilding the drive, migrating RAID on the
drive, migrating or expanding the capacity of
the strip size, expanding the capacity of the
logical drive, or erasing the drive.
A drive is a member of one or more logical
drives and a drive failure is predicted.
Drive is not configured, and drive failure is
predicted.
Drive has failed.
In the drive, the RAID controller has not
achieved the configuration.