Qinq Ethernet-Type Service-Tag - HP A5830 Series Command Reference Manual

On a port with basic QinQ or customer-side QinQ enabled, the switch judges whether a frame is VLAN
tagged based on the CVLAN TPID value globally configured.
For more information about customer-side QinQ, see the chapter ―VLAN mapping configuration.‖
Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag
View
System view
Default level
2: System level
Parameter
hex-value: Specifies the Hexadecimal TPID value, ranging from 0x0001 to 0xFFFF. However, do not set it
to any of the protocol type values listed in
Table 44 Common protocol type values
Protocol type
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1X
Cluster
Reserved
Example
# Set the TPID value in the CVLAN tags to 0x8200 globally.
<Sysname> system-view
[Sysname] qinq ethernet-type customer-tag 8200

qinq ethernet-type service-tag

Description
Use the qinq ethernet-type service-tag command to configure the TPID value in SVLAN tags.
Table 44.
Value
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
203