Settings - ABB RED650 Technical Manual

1MRK 505 394-UEN A
7.1.5
Table 45: ZMFPDIS Non group settings (basic)
Name Values (Range)
GlobalBaseSel
ZDbRepInt
ZMax
ZRepTyp
ZAngDbRepInt
Line differential protection RED650 2.2 IEC
Technical manual
Name
STNDZRV
STND
STNDL1
STNDL2
STNDL3
STNDPE
STFWL1
STFWL2
STFWL3
STFWPE
STRVL1
STRVL2
STRVL3
STRVPE
STFW1PH
STFW2PH
STFW3PH
STPE
STPP

Settings

Unit
1 - 12 -
1 - 100000 Type
0.0 - 5000.0 Ohm
Cyclic -
Dead band
Int deadband
Dead band & 5s
Cyclic
Dead band & 30s
Cyclic
Dead band & 1min
Cyclic
1 - 100000 Type
Type Description
BOOLEAN Start in any phase or phases from zone RV - any
direction
BOOLEAN Fault detected in any phase or phases - any
direction
BOOLEAN Fault detected in phase L1 - any direction
BOOLEAN Fault detected in phase L2 - any direction
BOOLEAN Fault detected in phase L3 - any direction
BOOLEAN Fault with earth connection detected in any phase
or phases - any direction
BOOLEAN Fault detected in phase L1 - forward direction
BOOLEAN Fault detected in phase L2 - forward direction
BOOLEAN Fault detected in phase L3 - forward direction
BOOLEAN Fault with earth connection detected - forward
direction
BOOLEAN Fault detected in phase L1 - reverse direction
BOOLEAN Fault detected in phase L2 - reverse direction
BOOLEAN Fault detected in phase L3 - reverse direction
BOOLEAN Fault with earth connection detected - reverse
direction
BOOLEAN Single-phase fault detected - forward direction
BOOLEAN Two-phase fault detected - forward direction
BOOLEAN Three-phase fault detected - forward direction
BOOLEAN Ph-E zone measurement enabled - any direction
BOOLEAN Ph-Ph zone measurement enabled - any direction
Step Default
1 1
1 10
0.1 1500.0
- Cyclic
1 10
Section 7
Impedance protection
Description
Selection of one of the Global Base
Value groups
Cycl: Report interval (s), Db: In % of
range, Int Db: In %s
Maximum value in ohm
Reporting type
Cycl: Report interval (s), Db: In % of
range, Int Db: In %s
PID-7066-SETTINGS v1
115