Wall Mounting Dimensions; Mounting Alternatives; Flush Mounting; Overview - ABB RED650 Technical Manual

1MRK 505 394-UEN A
22.3.5
IEC04000471 V2 EN-US
Figure 398: Wall mounting
Case size (mm) A
6U, 1/2 x 19" 292.0
22.4
22.4.1
22.4.1.1
Line differential protection RED650 2.2 IEC
Technical manual

Wall mounting dimensions

B C
267.1 272.8

Mounting alternatives

Flush mounting

Overview

The flush mounting kit can be used for the 1/2 x 19" case size.
Only a single case can be mounted in each cut-out on the cubicle panel, for class
IP54 protection. The screws from the IED shall be used to fasten the fasteners to
the IED.
Flush mounting cannot be used for side-by-side mounted IEDs
when IP54 class must be fulfilled. Only IP20 class can be obtained
when mounting two cases side-by-side in one (1) cut-out.
IEC04000471-2-en.vsd
D E
390.0 243.0
Section 22
IED hardware
M11569-3 v4
IP11721-1 v1
IP10303-1 v1
M11967-3 v5
851