Installation Of Wing Tip Position Light; Removal And Installation Of Tail Position Light; Anti-Collision Strobe Lighting; Removal Of Red Fin Tip Anti-Collision Light - Piper Navajo Chieftain PA-31-350 Service Manual

NAVAJO CHIEFTAIN SERVICE MANUAL
11-77. INSTALLATION OF WING TIP POSITION LIGHT.
a. Install the bulb and lens.
b. Secure lens retainer with appropriate screw.
c. Place plexiglas cover in position on wing tip and secure with appropriate screws.
11-78. REMOVAL OF TAIL POSITION LIGHT. The tail position light is located on the tip of the tail.
a. Remove the screws securing the lens retainer to the light assembly, and remove lens retainer and
lens.
b. Remove bulb.
NOTE
To remove the complete taillight assembly, disconnect retaining
nut on the electrical connection at the back of the taillight. The
assembly is now free.
11-79. INSTALLATION OF TAIL POSITION LIGHT.
a. Install the bulb.
b. Install lens retainer and secure with the appropriate screws.
11-80. ANTI-COLLISION STROBE LIGHTING.
11-81. REMOVAL OF RED FIN TIP ANTI-COLLISION LIGHT. (Serial Nos. 31-7305001 to 31-7305052.)
a. Loosen screw securing the ring clamp to the base of the red strobe lens enough to remove the ring
clamp.
b. Remove the lens.
c. Pull strobe tube out of its socket.
NOTE
If removal of the tube socket is desired, proceed to the next step.
If not, proceed to paragraph 11-82, step d.
d. Remove screws securing fin tip to the fin.
e. Lift fin tip and disconnect electrical connector inside fin tip.
f.
Remove screws securing socket assembly to fin tip. Remove socket assembly.
11-82. INSTALLATION OF RED FIN TIP ANTI-COLLISION LIGHT. (Serial Nos. 31-7305001 to
31-7305052.)
a. Install socket assembly on fin tip and secure with appropriate screws.
b. Connect the three pin connector to the harness from the strobe power supply.
c. Install fin tip on fin and secure with appropriate screws.
d. Install strobe tube into its socket.
e. Install lens.
f. Secure lens with ring clamp.
Revised: 2/8/82 ELECTRICAL SYSTEM
3D24