Landing Light Installation; Removal Of Aileron; Installation Of Aileron - Piper Navajo Chieftain PA-31-350 Service Manual

ADJUSTMENT
SCREW
NAVAJO CHIEFTAIN SERVICE MANUAL
116
Figure 4-1. Landing Light Installation
4-13. INSTALLATION OF LANDING LIGHT.
a.
To install the landing light lamps, attach the electrical leads to the lamp(s) and place against the
mounting pad. Position the attachment plate and secure with screws only tight enough to
allow the lamps
to fit snug in the mount.
b.
To install the landing light assembly, position the assembly against the strut housing
with the
bottom of the mounting bracket 5.63 inches up from the bottom of the housing. (Refer
to Figure 4-1.)
Align the bracket longitudinally and secure with clamps. The light beam angle may be
adjusted by the
adjustment screws at the sides of the bracket and tilting as desired.
4-14. AILERON.
4-15. REMOVAL OF AILERON. (Refer to Figure 4-2.)
a.
Remove the wing tip in accordance with paragraph 4-5.
b.
Remove the wing tip aft attachment rib.
c.
Disconnect the aileron control rod.
d.
At the right aileron, disconnect the trim tab control rod.
e.
Remove the hinge bolts and remove the aileron.
4-16. INSTALLATION OF AILERON. (Refer to Figure 4-2.)
a.
Place the aileron in position, install hinge bolts and torque.
b.
If the right aileron was removed, connect the trim tab control rod.
c.
Connect the aileron control rod.
d.
Attach the wing tip attachment rib.
e.
Install the wing tip in accordance with paragraph 4-6.
Reissued: 9/23/80
STRUCTURES
1E23