Lubricating Sleeve View; Lubricating Ferrule Shoulder View - Piper Navajo Chieftain PA-31-350 Service Manual

COAT
GO-JO NO LOK
LUBRICATE
NAVAJO CHIEFTAIN SERVICE MANUAL
C467
FLUOROCARBON SPRAY
Figure 8-33. Lubricating Sleeve Figure 8-34. Lubricating Ferrule Shoulder
b.
Using the needle or pencil unscrew the spring.
c. Slide insulating sleeve and spring retainer assembly off end of lead assembly.
d. Replace defective component and reassemble as follows:
1. Fabricate a tool as shown in Figure 8-27 for installing the insulating sleeves over cable
terminals.
2. Slide elbow assembly over lead and attach nut finger tight to ferrule.
3. Push the fabricated tool through insulating sleeve and spring retainer assembly as shown in
Figure 8-28. Screw the cable terminal into the tool.
4. Work insulating sleeve and spring retainer assembly into position over the cable and unscrew
the tool. Install contact spring on cable terminal.
NOTE
It may be necessary to lubricate the cable and insulating sleeve
with a thin film of DC 200 (200,000 centistokes) or commercial
grade alcohol to facilitate assembly.
e. To replace one of the lead assemblies proceed as follows:
1. Remove clamps and brackets from defective lead assembly. Cut cable ties from assembly
and discard.
2. Cut the eyelet from the lead and remove grommet.
3. Grip the ferrule of the lead with a pair of vise gripe or water pump pliers and with a
twist-pull action remove the ferrule from the cover and discard ferrule. Pull lead from cover.
4.
Thread pre-stripped end of replacement lead through cover.
Reissued: 9/23/80
POWER PLANT
2J4