336
-
METAL STAMP "R 5000086"
4.44 RAD.
IN 0.12 CHARACTERS
FULL RAD.
INSTRUCTIONS:
1. Disassemble brake assembly per paragraph 7-77 and remove snow shield.
2. Add four slotted holes to snow shield as shown above. Pilot drill and cut slots as required.
No special tools required.
3. Metal stamp R5000086 in 0.12 inch characters as shown above.
4. Touch-up slots with Aluminum Lacquer Specification TT-L-32.
5. Reassemble brake assembly per paragraph 7-80.
Figure 7-28. Snow Shield Modification
Reissued: 9/23/80
LANDING GEAR AND BRAKE SYSTEM
NAVAJO CHIEFTAIN SERVICE MANUAL
2F23