Removal; Installation; Strobe Anti-Collision Lights Description (Warrior Iii); Removal Of Wing Tip Strobe Light (Warrior Iii) - Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual

PIPER CHEROKEE WARRIOR SERV I C E M A N U A L
c. Secure lens to mounting plate by the clamp previously removed.
d. Reconnect electrical plugs underneath fin tip.
e. Replace fin tip and secure with appropriate screws.
11-106. ROTATING BEACON TYPE ANTI-COLLISION LIGHT. (WARRIOR/WARRIOR II)

11-107. REMOVAL.

a. Loosen screw securing clamp around rotating beacon lens. Remove clamp and lens.
b. Remove light bulb from bayonet socket.
To remove complete rotating beacon assembly remove screws
securing it to rudder tip. Next pull rotating beacon assembly
out and disconnect the electrical leads. Take note of their
placement to facilitate reinstallation. Rotating beacon assembly
can now be removed.

11-108. INSTALLATION.

a. Install light bulb in bayonet socket.
b. Replace lens and clamp and secure by tightening screw on clamps.
11-109. STROBE ANTI-COLLISION LIGHTS DESCRIPTION. (WARRIOR III)
A white strobe anti-collision light is installed in each wing tip in the same assembly with navigation
lights. These units are rated to flash approximately 45 times per minute. The anti-collision are controlled by
an independent rocker switch (STROBE LIGHT)located on the instrument panel, through a power supply unit
located in the aft section of the fuselage. The circuit is protected by a 5 amp ANTI-COLL LIGHTS circuit
breaker. (Refer to Figure 11-57.)
11-110. REMOVAL OF WING TIP STROBE LIGHT. (WARRIOR III)
a. Ensure that the BATT MASTR and STROB LIGHT switches are in OFF position.
b. Disengage (pull out) ANTI-COLL LIGHTS circuit breaker.
c. Remove two screws securing navigation light cover and remove cover.
d. Remove three screws securing navigation light bracket assembly
e. Separate light bracket assembly from wing tip by pulling out on bracket assembly.
f. Cut Ty-Wrap securing connector together. Pull connector apart.
g. Remove wire protection grommet from light bracket.
h. Remove defective lamp from light bracket.
11-111. INSTALLATION OF WING TIP STROBE LIGHT. (WARRIOR III)
a. Route wires from new lamp through the hole in navigation light bracket.
b. Install wire protection grommet onto light bracket.
c. Connect plug to receptacle. Ensure like color wires on plug and receptacle are aligned or opposite
each other. Secure plug and receptacle connection with a Ty-Wrap.
d. Position strobe and navigation light assembly in place on wing tip.
e. Secure navigation light assembly and bracket to wing tip with the three screws removed during
disassembly.
f. Set (push in) ANTI-COLL LIGHTS circuit breaker.
g. Verify that bulb(s) is/are working by selecting BATT MASTR and STROB LIGHT switches ON
and checking that both strobe lights flash. Select BATT MASTR and STROB LIGHT switches OFF.
h. Install navigation light cover. Check that red or green lens, as appropriate, are properly located.
Secure cover with the two screws removed during disassembly.
Revised: February 28, 1995
NOTE
2G7
Island Enterprises
ELECTRICAL SYSTEM