Wing Group; Removal Of Wing Tip; Repair Of Wing Tip; Removal Of Wing Navigation Light - Piper Navajo Chieftain PA-31-350 Service Manual

NAVAJO CHIEFTAIN SERVICE MANUAL
4-3. WING GROUP.
4-4. WING TIP.
4-5. REMOVAL OF WING TIP.
a.
Remove the screws attaching the wing tip to the wing.
b. Pull the wing tip off far enough to disconnect the navigation light positive wire at the
quick-disconnect fitting and remove the screw securing the ground wire to the wing structure.
c.
Remove the wing tip completely.
4-6. REPAIR OF WING TIP. The wing tip may be repaired in accordance with fiberglass repair procedures
in the Structural Repairs portion of this section.
4-7. INSTALLATION OF WING TIP.
a. Attach the ground wire terminal to the wing structure and connect the positive electrical leads
together.
b.
Position the wing tip on the wing and start all screws with washers.
c.
With all screws in place, tighten.
4-8. WING NAVIGATION LIGHT.
4-9. REMOVAL OF WING NAVIGATION LIGHT.
a. To remove bulb, remove the screws securing the clear window.
b. Remove screws securing the lens retainer.
c.
Remove lens and bulb.
NOTE
To remove the complete lamp assembly, the wing tip must be
removed.
4-10. INSTALLATION OF WING NAVIGATION LIGHT.
a.
Install bulb, lens gasket and secure retainer.
b. Put light window in position and secure.
4-11. LANDING LIGHT.
4-12. REMOVAL OF LANDING LIGHT. (Refer to Figure 4-1.)
a. To remove either lamp from the landing light mounting plate, remove the screws from the front
of the lamp attachment plate and then remove the attachment plate from the lamp mounting plate. When
removing the attachment plate, use caution not to drop the lamps. Disconnect the electrical leads from the
desired lamps.
b. To remove the lamp light assembly from the gear strut, disconnect the electrical leads from the
lamps and release the clamps that secure the assembly to the strut housing.
Reissued: 9/23/80
STRUCTURES
1E22