Wing Flap Actuator Cable - 100 Hour Inspection - Piper Navajo Chieftain PA-31-350 Service Manual

NAVAJO CHIEFTAIN SERVICE MANUAL
1020
.230 to .260 including See Instructions (Paragraph 3-9)
Figure 3-2. Wing Flap Actuator Cable - 100 Hour Inspection
d. If inspection reveals that either of the shaft assemblies are not properly installed. it will be
necessary to correct as follows:
1. Cut safety wire from nut and disconnect shaft assembly from transmission.
2. Align and insert tang on shaft assembly into slot in transmission. Tighten nut finger tight
and wrench not over 1/16 turn from finger tight. When installed by this method the dimension between the
nut and transmission will be as noted in Step c. thus ensuring that the end of shaft housing is firmly seated
against transmission. Safety nut with .040 wire.
e.
If flexible shaft assembly is disconnected from transmission or from flap motor, it will be
necessary to check the flexible shaft rigging as follows:
1. As the last step after the flap system has been rigged and the flex shaft nut has been
tightened and safetied. the flex shaft is to be disconnected at the flap motor. Inspect swaged end of inner cable
for wear or looseness.
Revised: 10/15/82
lD18
INSPECTION